Post by: ackrockboogie on October 09, 2014, 04:32:42 pm
I'm new to Outerra Anteworld and the forum so please excuse my ignorance if this issue has already been addressed.
I just bought Anteworld yesterday and am experiencing an issue with the default aircraft keep pulling up regardless of how far forward i push my yoke.
Also, the trim doesn't seem to work correctly either.
Any ideas of what i could be doing wrong??
Thanks in advance.
Post by: PytonPago on October 10, 2014, 03:43:14 am
Post by: Acetone on October 10, 2014, 10:16:09 am
Also, the trim doesn't seem to work correctly either.
You should see the trim value changing at the left bottom of your screen if the trim works properly. If you don't see any number, it probably means that your default key setting is not working for some reason.
Post by: ackrockboogie on October 10, 2014, 12:00:48 pm
Try re-setting the controlls - i know, the buttons and axes might be else at ohter joystics (mine was too) compared to the default settings - so re-sett the axes and the trim. If that doesnt help, post please what type it is and the .log file Cameny might look into it deeper then ...Python thanks alot for the reply. I did a simple reset to default and everything worked perfectly.
Thanks for your time.
Post by: ackrockboogie on October 10, 2014, 12:01:51 pm
Acetone, thank you also for your time and help. I finally got it working right!Also, the trim doesn't seem to work correctly either.
You should see the trim value changing at the left bottom of your screen if the trim works properly. If you don't see any number, it probably means that your default key setting is not working for some reason.
Take care.