Topic: center of mass is considered at 0,0,0 instead of where the aircrft.xml tells it? (Read 6737 times)

krz9000 · « **on:** October 20, 2012, 04:10:22 pm »

i placed my plane with the nose at 0,0,0 and entered a CG of something like -2,0,-0.3 . the plane gets placed correctly but as soon as i start the simulation it tips on its nose as if the CG is at 0,0,0. if i start in midair the plane just nosedives

i red in a different threat that there are issues with the CG. do i have to move my plane to put 0,0,0 to the CG? or maybe i did something wrong somewhere else in the config? im confused

ZeosPantera · « **Reply #1 on:** October 20, 2012, 05:51:41 pm »

This same issue is probably plaguing the land vehicles as well. I asked Cameni to fix the CG on the 8x8 and he said he either couldn't find where it was hard coded or something. Not that I took that as an excuse just another issue needing to be resolved in beta.

ddenn · « **Reply #2 on:** October 21, 2012, 02:39:41 am »

Already reported and implemented - http://www.outerra.com/xtrac/index.fcgi/ticket/101

Outerra forum

News:

Author Topic: center of mass is considered at 0,0,0 instead of where the aircrft.xml tells it? (Read 6737 times)

krz9000

center of mass is considered at 0,0,0 instead of where the aircrft.xml tells it?

ZeosPantera

Re: center of mass is considered at 0,0,0 instead of where the aircrft.xml tells it?

ddenn

Re: center of mass is considered at 0,0,0 instead of where the aircrft.xml tells it?